Command Fusion Button Panel Interface 16xDry + 16xDim LED out

Prijs op aanvraag

Artikelnummer
SW16 CMF

Overview

The SW16 is used to interface physical buttons to the CFLink network. With 16 x Dry contact inputs, you can connect up to 16 momentary or toggle switches to control your automation system. The 16 channels of dimmable LED outputs allow you to show feedback states for the buttons, and 4 dimmable backlight LED outputs can be used to backlight your keypad if required.

Rules Engine

All CFLink devices, including the CF Mini, support a powerful rule triggering engine. This allows you to trigger macros to run when a specific event occurs - such as reading a specific value via the I/O ports, or on incoming data via the RS232 port. Using the rules engine, you can setup basic or complex automation actions.

Dimmable LED outputs

The 16 dimmable LED outputs and 4 dimmable backlight LED outputs can be controlled via the CFLink protocol. This allows you to not only turn these LEDs on and off, but you can set the dimming level of the individual outputs, in 100 steps. There are also commands to ramp between levels, blink the LED (set number of times or continously) and dim up/down in a loop. This means you can show all sorts of feedback states via these LED outputs. You could even use 3 channels of the LED outputs to drive a single RGB LED for multi-color feedback states.

Custom button panels

Although you could use any off the shelf button panel and wire the buttons up to the SW16, you could also create your own custom button panels to suit any task. Put a few buttons together on a wall plate material of your choosing, and create physical interfaces for industrial automation tasks.

Artikel document CommandFusion_SW16_Spec-Sheet.pdf
QuickReferenceGuide-SW16.pdf
25CommandFusion-Catalogue-2013.pdf
Merk CommandFusion
BxDxH in cm 8,14 x 7,64 x 3,15cm
Gewicht in Kg 0,11kg
Constructie materiaal Kunststof
Constructie materiaal specifiek Polycarbonate
Verkrijgbare kleuren Dark grey matte finish
Connectivity 40-pin ribbon cable (included). 16 digital inputs. 16 dimmable LED
CF-link Detachable 5-pin 3.81mm terminal block for CFLink BUS
Micro SD slot Spring-loaded memory expansion slot (card not included)
Power 9-30V DC, 24V DC regulated recommended 2W (power supply is not included)

Een moment gebuld a.u.b.