Command Fusion Ethernet & RS232 interface
Overview
The LAN Bridge is the Ethernet & RS232 gateway for all devices connected via the CFLink bus. It has many advanced networking features, including the ability to communicate via TCP Server, TCP Client, UDP Unicast and UDP Broadcast, all at the same time.
10 different communication slots can be defined, each with its own configuration of protocol type, port, and other options. A maximum of 25 total TCP socket connections can be shared between each defined slot.
Rules Engine
All CFLink devices, including the CF Mini, support a powerful rule triggering engine. This allows you to trigger macros to run when a specific event occurs - such as reading a specific value via the I/O ports, or on incoming data via the RS232 port. Using the rules engine, you can setup basic or complex automation actions.
Advanced Communications
Communication slots can be subscribed to each other, allowing advanced configurations such as TCP Client multiplexing. In other words, Ethernet devices that accept only one connection at a time can be extended by using the LAN Bridge to be that single connection, and then act as a server for all other clients to connect to.
Passthrough Configurations
Communication slot subscriptions can also be targeted directly to a specific CFLink device on the bus, even as far as a module slot number for modular controllers. This allows you to send and receive communications to CFLink end points, such as an RS232 port, without any CFLink protocol formatting. Just send the data that you want to be received by the RS232 device.
| Artikel document |
7CommandFusion-Catalogue-2013.pdf QuickReferenceGuide-LANBridge.pdf CommandFusion_LAN-Bridge_Spec-Sheet.pdf 39CommandFusion-Diagram-Commercial-Boardroom.pdf 38CommandFusion-Diagram-Residential-Whole-House.pdf |
| Merk | CommandFusion |
| BxDxH in cm | 8,14 x 7,64 x 4,1cm |
| Gewicht in Kg | 0,13kg |
| Constructie materiaal | Kunststof |
| Constructie materiaal specifiek | Polycarbonate |
| Verkrijgbare kleuren | Dark grey matte finish |
| CF-link | Detachable 5-pin 3.81mm terminal block for CFLink BUS |
| RS-232 | 6-pin RJ12 female port for RS232 control of devices; or programming mode which allows both programming and external control of the CFLink BUS devices via RS232. |
| Ethernet | RJ45 female port for Ethernet connectivity, with two LED status lights for data transmission and connectivity status. |
| Micro SD slot | Spring-loaded memory expansion slot |
| Power | 9-30V DC, 24V DC regulated recommended 2W (power supply is not included) |
