USB to CAN converter, for use withAXIOM, NEOS AXS and PC series.

Prijs op aanvraag

Artikelnummer
USB2CAN PRL

USB2CAN converter

To work with a Pronet network you need a USB2CAN converter that converts the USB data flow into the CAN bus. The USB2CAN converter needs to be connected to a USB 2.0 full speed port.

USB2CAN Features:

ARM7 microcontroller inside

Galvanic isolation 500 V

Voltage supply via USB bus USB 2.0 full speed

High productivity on 1Mbit CAN bus speed

Wide CAN bus baud rate range: 10-1000 Kbit/s

Compliant with CAN specifications 2.0A (11-bit ID) and 2.0B (29-bit ID)

Firmware upgrade via bootloader Drivers for Windows 2000, Windows XP, Windows Vista,Windows 7

To install correctly the software driver for the USB2CAN converter see "Installation" and "Drivers" paragraphs in the included or online documentation.

When you connect the converter to the USB port of the PC, the LED on the top lights RED: this mean that it is powered but the converter is not working yet.

The first time you go "online", the Pronet software application starts to control the network via the USB2CAN controller, sending and

receiving datas from connected devices. If everything is OK the LED on the top of the converter lights GREEN indicating the activities

on the network.

If there is a problem with the software driver, with network bus or there is a problem on the converter the LED flashes red and/or green.

STATUS LED operation

RED/GREEN toggling PC USB driver isn't installed

RED steady converter is not working

GREEN steady converter is working

GREEN blinking slow there is a problem in the bus

GREEN blinking fast there is a problem in the bus

RED blinking slow there is a problem in the bus

RED and GREEN steady Service mode

Merk Axiom

Een moment gebuld a.u.b.